Filter
Top Products
7
SECTION 3: UNPACKING INSTRUCTIONS
REMOVE UNIT FROM CARTON
• See Figure 2.
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e., owner’s manual, etc.).
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
Roll or slide unit out of carton. Check carton thoroughly for loose parts.
Figure 2
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it against
the engine by attaching rubber boot to a bolt or metal clip to the grounding post on the engine. See Figure 3
Figure 3
PUSH
REMOVE MANUAL & LOOSE PARTS
Spark Plug Wire
Spark Plug