Filter
Top Products
– 17 –
761-086a
762-046
1
2
12v
762-047
763-238a
q
w
AE00904
Battery Charging
cC
Do not use AC and DC power at the same time or
the generator may be damaged.
NOTE:
The generator DC rated voltage is 12V.
1. Wind the battery charging lead 2 or 3 turns around
the handle and plug into DC receptacle.
NOTE:
9 Make connections to the battery after starting the
engine.
9 Clamp the red wire to the positive (+) terminal and
the black wire to the negative (-) terminal of the
battery. Do not reverse these positions.
1 Red
2 Black
2. Start the engine.
3. Press in the DC protector and install the battery.
cC
9 Be sure the battery leads are properly connect-
ed.
9 Be sure the breather hose is properly connect-
ed and is not damaged or obstructed.
9 Reduce the load to the specified generator
rated output if the DC protector turns off. If it
turns off again, consult a Yamaha dealer.
NOTE:
Press to reset the DC protector.
1 “ON”
2 “OFF”
NOTE:
9 At full charge, electrolyte specific gravity is
between 1.26 and 1.28.
9 Check specific gravity hourly.
7CF-9-10-a 3/9/05 9:21 AM Page 17