Filter
Top Products
22
xPower600 Owners Manual
10.0 Battery Replacement
10.1 General Information About Battery Life
The battery used in xPower600 is a high quality, state-of-the-art design
that will serve as a reliable power source for years when properly
maintained.
To maximize battery life it is important to recharge xPower600s battery
after each use, recharge fully every three months if placed in storage,
and store in a location that maintains a temperature range of 32º to
100ºF (0º to 40ºC). Also, discharging the battery below 10.0 Volts will
damage the battery and shorten its life.
IMPORTANT: The battery is covered under warranty only when it is
properly maintained.
10.2 Replacing xPower600s Internal Battery
Before attempting to replace the battery, make sure any charging cables,
DC accessories, or AC products are disconnected from xPower600 and
that the AC Outlets Switch is turned off. Also, read this entire section
before disassembling the unit.
WARNING: To avoid potentially serious injury follow these precautions
when working with batteries:
1. Someone should be within range of your voice or close enough to
come to your aid when you work near a lead-acid battery.
2. Have plenty of fresh water and soap nearby in case battery acid
contacts skin, clothing, or eyes.
3. Wear complete eye protection and clothing protection. Avoid
touching your eyes while working near batteries.
4. If battery acid contacts skin or clothing, wash immediately with
soap and water. If acid enters your eye. immediately flood it with
running cold water for at least twenty minutes and get medical
attention immediately.
5. Keep a supply of baking soda on hand in the area of the batteries.
Baking soda neutralizes lead-acid battery electrolyte.
6. NEVER smoke or allow a spark or flame in vicinity of the engine or
batteries.
7. Be extra cautious to reduce the risk of dropping a metal tool on the
battery. It might spark or short-circuit the battery or other electrical
parts that may cause an explosion.