Filter
Top Products
Rear Collection System Installation
1. Attach Muffler Tail Pipe and Clamp
• The tail pipe must be installed to direct the exhaust away
from the bags on the rear collection system. Slide end onto
existing muffler exhaust pipe. Orient the tail pipe so that it
directs the exhaust to the right side of the mower. This will
prevent excess heat exposure to the grass collection bags.
• Use enclosed screw to secure the tail pipe to the muffler.
2. Bolt on Grass Collection Receptacle Frame
Using two 1/2” bolts and nuts, attach the grass collection receptacle frame to the
back of the rear engine guard, as shown in the illustrated parts list. The enclosed
thick washer should be installed between the engine guard and the grass
collection receptacle frame.
3. Move the Rear Motor Supports
• Raise rear of mower frame. Be certain that the machine
is securely attached to jack or lift. Place block supports
or jack stands under the mower and lower the frame
onto them by lowering the lift/jack.
• Remove the rear wheels and unbolt the four bolts se-
curing the wheel motor supports to the side of the
mower frame. It is not necessary to remove the wheel
motor from the wheel motor support.
• Reposition the wheel motor support in the furthest
rear- ward position, as shown. It may be necessary to
adjust the hydraulic lines exiting the wheel motor
using a 7/8” and 13/16” wrench. Do not fully tighten
wheel motor support bolts at this time.
• Attach the receptacle frame side support. The lower portion of the side supports
will utilize the rearmost upper bolt on the wheel motor support. Attach the upper
support arms using two 3/8” bolts and nuts on each side support.
• Tighten all hardware.
• Mount the rear wheels and tighten all lug nuts. Lower mower from raised posi-
tion.
• Adjust rear brake shoes to effectively grip tire in new position.