Filter
Top Products
Install New Deck Cover
For 48” Mower Deck
48” Deck Cover Stud Configuration
3
1. Place offset stud adapter on existing deck
cover stud.
2. Secure in place with the supplied 3/8”
flange nut. Do not tighten completely.
. Place deck cover on mower deck and verify
the correct stud location. Remove Cover and
tighten nut.
4. Place another 3/8” nut on the stud adapter
nd adjust location to properly support deck
over when installed.
a
c
5. Place new deck cover on mower deck and
tighten deck knob.
For 52” Mower Deck
3
1. Remove current deck stud and hardware
2. Attach original deck stud (previously removed) to
offset stud adapter using two 3/8” nuts. Flange face
of nut should contact stud adapter. Tighten firmly.
. Attach stud adapter, as shown, to the mower deck
using the original mounting hole, and two 3/8” flange
nuts. Flange face must contact deck surface. Do not
ghten, until stud placement is verified by mounting
eck cover.
ti
d
4. Thread on another 3/8” nut, flange-sideup, onto
the original deck stud. This will support the deck
cover. Nut should be adjusted to allow proper
support when deck cover is in place. Verify stud
placement with cover and tighten stud to mower
deck.
5. Place deck cover on mower deck and fasten.
For 61” Mower Deck
All 61” Deck machines will use the existing
threaded deck stud and knob. Make any necessary
adjustments to the deck cover stud to insure that
the deck cover is level with the deck cover posts.