Filter
Top Products
• Using a rubber mallet, gently hammer the pulley assembly onto the spindle shaft. It
is necessary to maximize the engagement of the pulley and the spindle shaft.
• Tighten the hub bolts with a 7/16” wrench. Alternate bolts when tightening to
maintain a balanced load on each bolt.
Blower Installation
1. Mounting the Blower to the Deck
Lift the blower and insert the front tab of the bracket into the mating hole on the
deck-top bracket. The rear tab on the Adapter Bracket should fit securely into
the rear portion of the deck-top bracket.
2. Check for Belt Interference
Certain earlier production models will require that
a belt cover support post be hammered down,
out of the path of the belt. Only perform this if a
deck cover post is in the path of the blower belt
or within an inch thereof.