Filter
Top Products
25
Critical Application Models
Thread
Locker
Torque
Range (ft-lbs)
Torque
Sticks
Wheel motor bolts (Securing
motor to support)
Big/Small Stander, RH,
WSES, Velke
Loctite
2760
40-50 50
Wheel motor bolts / nuts
(Securing motor to support)
ZK, MMZ, Sentar3 N/A 103-125 110
Clutch to engine shaft All Models
Loctite
2760
50-55 50
Big Stander (MF14) 175-225 160
ZK, MMZ, Sentar3 (15E) 160-240 160
All Others (12P) 138-158 130
Wheel lug nuts All Models N/A 80-90 90
Split Hub (Spindle & Drive) (Gr 8) All Models N/A 13-17 n/a
N/AWheel hub to wheel motor
Torque Specifications
5.13 Cleaning the Mower
The underside of the mower deck should be checked and cleaned twice daily and more often if the grass
being mowed is lush or wet. The entire mower should be cleaned daily at the end of the work day.
Cleaning should be done with a leaf blower or low-pressure compressed air. Wash with water only when
necessary and do not use a pressure washer or nozzle as the water can enter bearings and electrical
connections causing an electrical short, rust and corrosion. When washing with water, avoid spraying near
the hydro cap and do so when the unit has cooled down. Washing a hot machine can cause various unseen
system damage. If water is used for cleaning, immediately dry it with a leaf blower or low-pressure
compressed air and run with blades engaged for approximately 10 minutes. Once the wash is complete,
always lubricate and grease all applicable areas.
5.14 Torque Specs
5.15 Spindle and Drive Pulley Split hub R&R
• Remove 2, ¼” bolts from split hub and install in threaded holes in hub.
• Slowly tighten each bolt, alternating as you tighten bolts against the pulley.
• The hub will separate from the pulley.
• Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley
and spindle shaft.
Assembly
hole
Threaded
Removal
holes
Assembly
hole
Tightening will
separate the hub
from the pulley