Filter
Top Products
22
5.4 Spring platform Adjustment
The factory setting is both springs set at the most forward position. The more rearward the spring position,
the stiffer the platform gets. Adjustment will be to preference of feel. The two adjustment springs should at
all times, be positioned next to each other not one forward or back more than the other. To adjust, loosen
each spring retaining bolt from the top just enough to slide it, then tighten with impact wrench. The nut may
spin using hand wrench. NOTE, do not loosen too much, if the nut falls off, the foot platform will have to be
removed to reinstall. There is an extra hole for a third spring for operators heavy enough to bottom out the
duel spring stock set up.
5.5 Hydraulic System
Whenever servicing the hydraulic system, it is of the utmost importance to keep any dirt or debris from
getting into the system. Clean off all parts before disassembly and assembly. When any of the hydraulic
parts are disconnected or removed or when the oil is changed, air must be bled from the system. If air is
entrained in the system, loss of power, excessive heat, and damage to the hydraulic pumps may occur.
5.7 Hydro Oil Tank Check/Fill
Checking oil
• Ensure mower is on a level surface.
• Lift hinged pad and remove hex socket plug from oil level port on the back of the tank.
• Hydro oil should be at the bottom of the threads.
WARNING