WORX Tools WG320 Chainsaw User Manual


  Open as PDF
of 58
 
Cordless Limbing and Trimming Chain Saw EN
2322 2322
TROUBLESHOOTING
If your saw does not operate correctly check the following:
PROBLEMS POSSIBLE CAUSES POSSIBLE SOLUTION
•Toolwillnotstart. •Outofbattery. •Chargethebatterypack.
•Bar/chainoverheated.
•Chaintootight.
•Lubricationneeded.
•RefertoADJUSTING THE
CHAIN TENSION section.
•RefertoLUBRICATION
section.
•Chainisloose. •Chaintensionsetincorrectly.
•RefertoADJUSTING THE
CHAIN TENSION section.
•Poorcutquality.
•Chaintensionsetincorrectly.
•Chainneedsreplacement.
•RefertoADJUSTING THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
•Refertosectionsfor
CHANGING THE GUIDE
BAR AND CHAIN.
•Unitrunsbutdoesnotcut.
•Chaininstalledbackwards.
See Fig. H and illustration.
•RefertoCHANGING THE
GUIDE BAR AND CHAIN
section.
 previous next