Filter
Top Products
Cordless Limbing and Trimming Chain Saw EN
1312
1312
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemical: Work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
JAWSAW
®
SAFETY WARNINGS
1) Avoid Dangerous Environment - Don't use
appliances in damp or wet locations.
2) Don't Use In Rain.
3) Keep Children Away - All visitors should
be kept at a distance from work area. Keep
bystanders and pets 100 feet (30 m) away.
4) Dress Properly - Do not wear loose clothing
or jewelry. They can be caught in moving
parts. Use of work gloves and substantial
footwear is recommended when working
outdoors. Wear protective hair covering to
contain long hair.
5) Use Safety Glasses, Always use face or
dust mask if operation is dusty.
6) Use Right Appliance - Do not use appliance
for any job except that for which it is
intended.
7) Avoid Unintentional Starting - Don't carry
plugged-in appliance with finger on switch.
Be sure switch is off when plugging in.
8) Don't Force JAWSAW
®
- It will do the job
better and with less likelihood of a risk of
injury at the rate for which it was designed.
9) Don't Overreach - Keep proper footing and
balance at all times.
10) Stay Alert - Watch what you are doing. Use
common sense. Do not operate appliance
when you are tired.
11) Store Idle Appliances Indoors - When not in
use, appliances should be stored indoors in
dry, and high or locked-up place - out of
reach of children.
12) Maintain JAWSAW
®
With Care - Keep
cutting edge sharp and clean for best
performance and to reduce the risk of injury.
Follow instructions for lubricating and
changing accessories. Inspect appliance
cord periodically, and if damaged, have it
repaired by an authorized service facility.
Inspect extension cords periodically and
replace if damaged. Keep handles dry,
clean, and free from oil and grease.
13) Check Damaged Parts - Before further use
of the appliance, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
14) Keep Work Area Clean.
Cluttered areas invite injuries.
Do not start cutting until you have a clear
work area, secure footing, and a planned
retreat path from the falling limbs.
15) Consider Work Area Environment.
Use extreme caution when cutting small
size brush and saplings because the
slender material may catch the saw chain
and be whipped toward you or pull you off
balance.
Do not operate JAWSAW
®
in a tree unless
specifically trained to do so.
When cutting a limb that is under tension
be alert for spring back so that you will not
be struck when the tension in the wood
fibers is released.
Don’t expose chain saw to rain.
Don’t use JAWSAW
®
in damp or wet
locations.
Do not use JAWSAW
®
in presence of
flammable liquids or gases.
16) Guard Against Electric Shock
Prevent body contact with grounded
surfaces. For example: metal pipes, wire
fences.
17) Carrying JAWSAW
®
Carry the JAWSAW
®
by the front handle
vertically by the rear handle with the saw
stopped and finger off the switch.
18) Keep all parts of the body away from the
saw chain when the motor is operating.
Before you start the saw, make sure the
saw chain is not contacting anything.