WORX Tools WG320 Chainsaw User Manual


 
1312
Cordless Limbing and Trimming Chain Saw EN
1312
ADDITIONAL SAFETY WARNINGS FOR
JAWSAW
®
1. Pre-plan a safe exit from falling branches
and debris. Ensure the exit route is clear
of obstacles that would prevent or hinder
movement. Remember freshly cut bark and
wet grass is slippery.
2. Be aware of the direction that a branch may
fall. Consider all conditions that may affect
the direction of fall. Including:
a. The intended direction of fall.
b. The natural lean of the branch.
c. Any unusual heavy limb structure or decay.
d. Surrounding trees and obstacles including
overhead power lines.
e. The wind speed and direction.
3. The safe distance between a branch
and debris to be felled and bystanders,
buildings, and other objects is at least
2 ½ times the length of the branch. Any
bystander, building, or object within this
distance is at risk from being struck by the
falling branch.
4. Begin and continue cutting only with the
chain moving at full speed.
5. When using the Extension pole to cut the
branches on a tree, make sure to keep a
firm footing and balance. Do not stand the
position where the branch may land after
being cut.
6. Before cutting is started, consider the
natural lean of the tree, the wind direction
to judge which way the branch will fall.
7. Remove dirt, stones, loose bark, nails,
staples, and wire from the branch where
you plan to make your cut.
8. The machine shall not be used in any
position that causes any part to come
within 33 feet (10m) of overhead electrical
lines;
9. Theoperatingpositionsaredangerous;the
operator may be struck by falling branches
or by those that rebound after hitting the
ground. Remove the branches in sections.
10. Do not use this tool to cut branches or
limbs over 4 inches (10 cm) in diameter, the
branch or limb must fit completely in the
jaw opening.
11. Fatigue causes carelessness. Be more
cautious before rest periods and towards
the end of your shift.
12. Follow the instructions in your operator’s
manual for starting the JAWSAW
®
and
control the JAWSAW
®
with a firm grip on
both handles when it is in operation. .Keep
handles dry, clean, and free from oil and
grease.
13. Always transport JAWSAW
®
with the guide
bar and chain inside the protection guard.
14. A JAWSAW
®
is recommended for two-
handed use. Serious injury to the operator,
helpers, and/or bystanders can result from
one-handed operation.
15. This electrically powered saw is classified
by CSA as a Class 2C saw. It is intended
for infrequent use by homeowners,
cottagers, and campers, and for such
general applications as clearing, pruning,
cutting firewood, etc. Prolonged periods of
operation can cause circulatory problems
in the user’s hands due to vibration. For
such use, it may be appropriate to use a
saw having an anti-vibration feature.
16. Before you start the JAWSAW
®
make sure
the chain is not in contact with anything.
17. Be sure to remove any adjusting keys,
tools, or wrenches before turning on the
JAWSAW
®
.
18. Personal protective clothing required by
your safety organizations, government
regulations, or your employer should
be used. At all times when using the
JAWSAW
®
, snug-fitting clothing, protective
eyewear, safety footwear, and hand, leg,
and hearing protection should be worn.
NOTE: Personal protective clothing should
meet the requirements of applicable
standards.
SAFETY WARNINGS FOR ALL BATTERY
OPERATED GARDENING APPLIANCES
1. The instruction manual for all battery-
operated gardening appliances shall
contain the following or equivalent
instructions:
a) Do not charge appliance in rain, or in wet
locations.
b) Do not use battery-operated appliance in
rain.
c) Remove or disconnect battery before
servicing, cleaning or removing material
from the gardening appliance.
d) Use only the following type and size
battery(ies):WA3525