Filter
Top Products
37 2
DELIVERY CHECKLIST
Inspect the mower thoroughly after assembly to be cer-
tain it is set up properly. The following checklist is a
reminder of points to inspect. Check off each item as it is
found satisfactory or after proper adjustment is made.
■■ Check operator's manual and familiarize the opera-
tor with all sections of it.
■■ Check that all safety shielding is in place.
■■ Check all bolts to be sure they are tight or adjusted
properly at hinged locations.
■■ Check that all cotter pins are properly installed.
■■ Check PTO driveline. Make sure it is the correct
length to operate mower with intended tractor.
■■ Check that all lubrication points with grease fittings
have been lubricated.
■■ Check that blades have been properly installed.
Check all blade bolts.
■■ Check mower attitude, after mounting on tractor.
■■ Check that gearbox is properly serviced and seals
are not leaking.
■■ Check shear bolt for proper grade and installation.
■■ All safety signs (decals) in place and readable.
■■ When the cutter is transported on a road or highway
at night or during the day, safety devices should be
used for adequate warning to operators of other
vehicles.
CHECKLISTS
IMPORTANT!
Gearbox was not filled at factory. It must be serviced before operating. Fill to
proper level with SAE 90 oil. Failure to service will result in damage to gearbox.
PRE-OPERATION CHECKLIST
(OWNER/OPERATOR RESPONSIBILITY)
____ Review and follow safety rules and safety signs on
pages 3 through 17.
____ Check that mower is properly and securely
attached to tractor.
____ Make sure driveline spring-activated locking pin or
locking balls operate freely and are seated firmly in
tractor PTO spline groove.
____ Lubricate all grease fitting locations. Make sure
PTO shaft slip joint is lubricated.
____ Check to be sure gear lube runs out the small
check plug on side of gearbox.
____ Check that all hardware is properly installed.
____ Check to ensure blades are sharp and secure and
cutting edge is positioned to lead in a counterclock-
wise rotation.
____ Check that all shields and guards are properly
installed and in good condition.
____ Check cutting height, front to rear attitude and top
link adjustment.
____ Place tractor PTO and transmission in neutral
before starting engine.
____ Set tractor PTO gear select lever for 540 rpm
operation.
____ Inspect area to be cut and remove stones,
branches or other hard objects that might be
thrown, causing injury or damage.
____ Check that PTO driveline shields are securely
locked and clears the front of the mower frame.
BLADE AND SPINDLE ASSEMBLY