Filter
Top Products
26 Dealer Check Lists
MAN0813 (3/17/2010)
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
make sure it is set up properly before delivering it to the
customer.
The following check list is a reminder of points to
inspect. Check off each item as it is found satisfactory,
corrections are made, or services are performed.
___ Check that all safety decals are installed and in
good condition. Replace if damaged.
___ Check that all shields and guards are properly
installed and in good condition. Replace if dam-
aged.
___ Check all bolts to be sure they are properly
torqued
___ Check and grease all lubrication points as identi-
fied in the Lubrication Maintenance illustration,
page 16.
___ Check the level of gearbox fluid before delivery.
Service, if required, as specified on page 16.
___ Check that blades have been properly installed
DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
___ Show customer how to make adjustments and
select proper PTO speed.
___ Instruct customer how to lubricate and explain
importance of lubrication.
___ Point out the safety decals. Explain their meaning
and the need to keep them in place and in good
condition. Emphasize the increased safety haz-
ards when instructions are not followed.
___ Point out all guards and shields. Explain their
importance and the safety hazards that exist
when not kept in place and in good condition.
___ Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment. Point out the manual safety rules,
explain their meanings, and emphasize the
increased safety hazards that exist when safety
rules are not followed.
___ Explain to customer the potential crushing haz-
ards of going underneath raised equipment.
Instruct customer that service work does not
require going underneath unit and never to do so.
___ Explain to customer that when equipment is
transported on a road or highway, safety devices
should be used to give adequate warning to oper-
ators of other vehicles.
___ Inform customer to operate PTO at 540 rpm max-
imum.
___ Explain to customer the importance of having the
correct PTO driveline length so that it does not
bottom out or come apart. Explain that it must be
checked as instructed in the manual whenever
using a different tractor.
___ Show customer the safe, proper procedures to be
used when mounting, dismounting, and storing
equipment.