Filter
Top Products
Hydraulic Installation 7
MAN0788 (1/16/2009)
HOSE KIT INSTALLATION
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
Air in hydraulic systems can cause erratic oper-
ation and allows loads or equipment components
to drop unexpectedly. When connecting equipment
or hoses or performing any hydraulic maintenance,
purge any air in hydraulic system by operating all
hydraulic functions several times. Do this before
putting into service or allowing anyone to
approach the equipment.
Protective hose sleeves must cover all hydrau-
lic hoses within 20 inches of the operator and be
secured onto metal hose fittings. Replace hoses or
sleeves if damaged or if protective sleeve cannot
be properly positioned or secured.
Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking before
starting power unit or using equipment. Check and
route hoses carefully to prevent damage. Hoses
must not be twisted, bent sharply, kinked, frayed,
pinched, or come into contact with any moving
parts. Operate moveable components through full
operational range to check clearances. Replace
any damaged hoses immediately.
1028835 Hose Kit Installation- - - - - - - - - - - - - Page 7
58025 Hose Kit Installation- - - - - - - - - - - - - - Page 10
1028835 HOSE KIT
General Description
These instructions are for operating the LUP126-2 or
LUP132-2 Loader using hose kit 1028835. To use one
of these hydraulic connections, the tractor must be
equipped with the manufacturer’s multi-function con-
trol valve located under the right front corner of the
operator’s platform. Hoses will be connected between
the loader and the hydraulic valve.
NOTE: Not all parts supplied with this hose kit are use
for this application.
Figure 6. Tractor Hydraulic Control Valve Location
DP4