Filter
Top Products
4 Mount Installation
MAN0788 (1/16/2009)
LOADER MOUNT INSTALLATION
■ Only use this mounting kit for mounting Woods
LUP126-2, LUP132-2 loaders on New Holland
®
T5040, T5050, T5060, T5070 2WD & FWA tractors
and Case IH
®
Farmall
®
85U, 95U and 105U 2WD &
FWA tractors. Any other use or modification of this
mounting kit may result in serious injury or death.
Safety instructions are important! Read all
attachment and power unit manuals; follow all
safety rules and safety decal information. (Replace-
ment manuals and safety decals are available from
your dealer. To locate your nearest dealer, check
the Dealer Locator at www.WoodsEquipment.com,
or in the United States and Canada call
1-800-319-6637.) Failure to follow instructions or
safety rules can result in serious injury or death.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
NOTICE
■ This equipment must be assembled and
installed on the customer’s tractor by the Woods
dealer. Dealer must thoroughly inspect equipment
and complete each item on the PRE-DELIVERY
CHECK LIST, DELIVERY CHECK LIST, and PROD-
UCT REGISTRATION before equipment is released
to the customer.
■ Clean threaded holes in the tractor chassis thor-
oughly using a tap of the proper size. Paint, rust, or
debris in the threads may not permit cap screws to
be installed and tightened correctly.
■ The Dealer must ensure that front tractor tires
do not contact the loader or loader mounting
brackets during operation. Tires must be checked
for possible contact at full turning radius and maxi-
mum axle oscillation before operating the loader.
See your tractor operator's manual for the proper
adjustment procedure and adjust the front axle
steering stops as required to obtain clearance.
CAUTION
Tractor Preparation
For installing this mounting kit, references to right, left,
forward, and rearward directions are determined from
the operator’s position in the tractor seat.
NOTE: OEM loader ready brackets are required to
install this loader mount.
1. Shut off engine and set parking brake during
installation.
2. Remove the tractor front weights and front weight
bracket if equipped.
3. Loose hardware securing OEM loader ready
brackets to tractor. This will help align mounting
holes with Woods loader mounts.
4. Follow tractor operator manual instructions and
adjust tires to the widest recommended setting to
increase the tractor stability.
As a valued customer, Woods appreciates your comments. Once loader mount and
hydraulic hoses have been installed, please take a few minutes to complete the Loader
Mount Evaluation sheet that was supplied with this mount. Your comments will help us
continue to bring you quality products.