Filter
Top Products
Safety 5
ST500 Snowblower SR (Rev. 1/2/2007)
When improperly operated, power unit can roll
over or upset. Use of rollover protective structure
(ROPS) with seat belt securely fastened will reduce
the possibility of injury or death if rollover or upset
occurs.
Never allow riders on power unit or attachment.
Do not operate PTO during transport.
Do not operate auxiliary hydraulics during
transport.
Look down and to the rear and make sure area
is clear before operating in reverse.
Do not operate or transport on steep slopes.
Use extreme care and reduce ground speed on
slopes and rough terrain.
Watch for hidden hazards on the terrain during
operation.
Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.
Do not operate power unit with attachment
removed. Attachment is required for power unit
stability.
MAINTENANCE
Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Make sure attachment is properly secured,
adjusted, and in good operating condition.
Never place any part of the body underneath
implement/attachment or between its moving parts
even when the engine has been turned off. Service
work does not require going underneath unit.
Mechanical failures, electrical failures, or operating
controls can cause equipment to drop.
Do not put Mow’n Machine into service unless
clutch is working properly. When the engine is at
full throttle, PTO-driven accessories must stop
within five seconds after the PTO switch is turned
to “OFF.” See your dealer for replacement clutches.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Tighten all bolts, nuts, and screws to torque
chart specifications. Check that all cotter pins are
installed securely to ensure equipment is in a safe
condition before putting unit into service.
Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section for
location.)
Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
STORAGE
Block equipment securely for storage.
Keep children and bystanders away from stor-
age area.
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!