Filter
Top Products
4 Safety
ST500 Snowblower SR (Rev. 1/2/2007)
TRAINING
Safety instructions are important! Read all
attachment and power unit manuals; follow all
safety rules and safety decal information. (Replace-
ment manuals and safety decals are available from
your dealer. To locate your nearest dealer, check
the Dealer Locator at www.WoodsEquipment.com,
or in the United States and Canada call 1-800-319-
6637.) Failure to follow instructions or safety rules
can result in serious injury or death.
If you do not understand any part of this manual
and need assistance, see your dealer.
Know your controls and how to stop engine and
attachment quickly in an emergency.
Operators must be instructed in and be capable
of the safe operation of the equipment, its attach-
ments, and all controls. Do not allow anyone to
operate this equipment without proper instructions.
Never allow children or untrained persons to
operate equipment.
PREPARATION
Check that all hardware is properly installed.
Always tighten to torque chart specifications
unless instructed otherwise in this manual.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Make sure attachment is properly secured,
adjusted, and in good operating condition.
Make sure the driveline spring-activated locking
collar slides freely and is seated firmly in power
unit PTO groove. Make sure the set screws
securely attach driveline to the attachment gearbox
shaft.
The safety interlock system was installed for
your protection. Do not disconnect, disable, over-
ride, or execute any action that would cause this
system to malfunction. If malfunction occurs, stop
all operation and contact dealer for repair.
Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section for
location.)
Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
When using weight transfer system, correct
counterweight must be used to maintain stability.
See counterweight chart in power unit manual or
contact dealer.
When equipped with ROPS, total vehicle weight
with all equipment, ballast, and operator must not
exceed 2,590 lbs.
Inspect and clear area of stones, branches, or
other hard objects that might be thrown, causing
injury or damage.
OPERATION
Never place any part of the body underneath
implement/attachment or between its moving parts
even when the engine has been turned off. Service
work does not require going underneath unit.
Mechanical failures, electrical failures, or operating
controls can cause equipment to drop.
Never place hands or body into discharge chute
or auger to unclog. Stored energy can cause auger
to quickly rotate when unclogging occurs and
cause severe injury or amputation. Stop engine,
remove key, disconnect driveline, and carefully
unclog, using a sturdy piece of wood.
Keep bystanders away from equipment.
Never direct discharge toward people, animals,
or property.
Do not operate or transport equipment while
under the influence of alcohol or drugs.
Operate only in daylight or good artificial light.
Keep hands, feet, hair, and clothing away from
equipment while engine is running. Stay clear of all
moving parts.
Safety is a primary concern in the design and
manufacture of our products. Unfortunately, our
efforts to provide safe equipment can be wiped
out by an operator’s single careless act.
In addition to the design and configuration of
equipment, hazard control and accident preven-
tion are dependent upon the awareness, concern,
judgement, and proper training of personnel
involved in the operation, transport, maintenance
and storage of equipment.
It has been said “The best safety device is an
informed, careful operator.” We ask you to be that
kind of operator.
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!