Filter
Top Products
Installation 7
MAN0258 (Rev. 12/14/2007)
VACUUM INSTALLATION
REMOVE DISCHARGE CHUTE
1. Remove mower deck discharge chute and hinge
by removing two carriage bolts (2) and nuts (3) and
lifting the chute (1) away from the deck.
2. Place the discharge chute and hinge on the chute
adapter (4) and secure with carriage bolts (2) and
nuts (3) previously removed.
NOTE: The discharge chute must be installed
whenever the vacuum housing assembly is
removed.
3. Install discharge chute and adapter to deck using
pivot mount, clevis shaft bracket, and lynch pin as
described in ‘Attach Discharge Chute” on page 8.
Figure 1. Discharge Removal
ATTACH HOSE ADAPTER
Figure 2. Hose Adapter Installation
1. Attach hose adapter (2) to vacuum housing (1)
using six whiz bolts (3) and whiz nuts (4).
NOTE: To prevent grass buildup inside the
adapter, install bolts with nuts (4) on the outside as
shown in Figure 2.
INSTALL VACUUM HOUSING
Figure 3. Vacuum Housing Installation
1. Install vacuum mount bracket (35) using three whiz
bolts (36) and whiz nuts (37).
2. Install vacuum front mount (38) using whiz bolts
(33) and whiz nuts (34).
3. Insert the pivot shaft (A) on the vacuum housing
assembly (1) into sleeve of vacuum mount (35).
60
34
59
C
D
6
27
5
-
1
60
34
62
61
61
34. 73163 5/16 NC Whiz nut
59. 75208 Discharge chute adapter
60. 78182 5/16 NC x 1 Carriage bolt
61. 78107 Discharge chute
62. 33000 Lynch pin
1
2
3
4
CD6281-1
1. Vacuum fan housing
2. 70570 Hose adapter
3. 70067 1/4 NC x 1/2 Whiz bolt
4. 70065 1/4 NC Whiz nut
1
34
38
33
35
36
37
37
A
CD6276-1
62
1. Vacuum housing assembly
33. 71851 5/16 NC x 3/4 Hex whiz bolt
34. 73163 5/16 NC Whiz nut
35. Vacuum mount (54" or 61" deck)
36. 71637 3/8 NC x 1 Hex whiz bolt
37. 70069 3/8 NC Whiz nut
38. 75109 Vacuum front mount
62. 33000 Lynch pin