Filter
Top Products
10 Assembly
MAN0118 (Rev. 12/23/2004)
Figure 3. 2-Way Angle Sweeper Installation
2-WAY ANGLE MOUNT KIT
(Figure 3)
Attach upper actuator mount (9) to square upright mast
on Sweeper broom head using 1/2 x 3 bolt and 1/2
locknut.
Mark Sweeper input driveshaft at 8-1/4 inches from the
center cross. Loosen the set screw retaining the rect-
angular shaft and remove it from the U-joint. Cut shaft
to proper length and reinstall shaft and secure with set
screws.
Position broom head in front of mount while inserting
broom head input shaft into sleeve assembly (4). Bolt
broom head to mount (1) using bolts provided with
broom head.
Attach fixed end of upper actuator (2) to mount using
1/2 x 2-1/2 bolt and 1/2 locknut. Attach rod end of actu-
ator to slots in upper actuator mount (9) using 1/2 x 2-
1/2 bolts and 1/2 locknut. Slide broom head left or right
until actuator lines up with upper mount. Do not over
tighten, rod must be able to float in slot. Attach wire
from actuator motor to black and white wires from the
switch box.
Attach extension spring (8) to hole in broom head mast
and to hole in main mount near rear actuator mounting
location.
Attach 2-1/2 clamp (7) and shield mount strap (6) to
round cross member of broom frame. Do not tighten
fully so shield may be adjusted. Attach power shaft
shield (5) to strap. Position shield so it can be bolted to
existing chain shield of broom head. Drill 2.343 (11/32)
dia holes in broom head shield to mount power shaft
shield. Bolt power shaft shield to broom head and
tighten all bolts and clamps.
Attach broom and mount to tractor according to instruc-
tion in the following section.
TRIM INPUT SHAFT
8--1/4
DRILL .343 (11/32) DIA
HOLES IN SWEEPSTER SHIELD
22
24
24
23
22
21
20
11
10
9
8
7
6
5
4
3
2
1
CD4647A
1. Broom mount
2. 12V Actuator
3. Universal half sheet
4. Universal half sleeve
5. Power shaft shield
6. Shield mount strap
7. 2-1/2" Clamp
8. Extension spring
9. Upper actuator mount
10. Caster wheel assembly right
11. Caster wheel assembly left
20. 5/16" x 3/4" NC Hex head cap screw
21. 5/16" NC Flanged hex lock nut
22. 1/2 NC x 2-1/2 Hex head cap screw
23. 1/2 NC x 3 Hex head cap screw
24. 1/2 NC Hex locknut