Filter
Top Products
Assembly 9
MAN0118 (Rev. 12/23/2004)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this sweeper is the responsibility of the
WOODS dealer. It should be delivered to the owner
completely assembled, lubricated, and adjusted for
normal cutting conditions.
FIXED ANGLE MOUNT KIT INSTALLATION
(Figure 2)
Mark Sweeper input driveshaft at 6-1/2 inches from the
center cross. Loosen the set screw retaining the rect-
angular shaft and remove it from the U-joint. Cut shaft
to proper length and reinstall shaft and secure with set
screws.
Position broom head in front of mount while inserting
broom head input shaft into sleeve assembly (7). Bolt
broom head to mount (1) using bolts provided with
broom head.
Attach height adjustment lever (2), and lever guide (18)
as shown. Pivot bolt (35) and nut (37) must be snug but
still allow the lever to rotate.
Secure one end of chain (17) to lug on adjustment
lever using washer (40) and cotter pin (30). Attach mid-
point of chain to slots in broom head lift arm. Secure
chain to slots using pin provided with the broom head.
Attach assist spring (16) to hole in sweeper mount.
Attach other end of spring to loose end of chain.
Attach broom and mount to tractor according to instruc-
tions on page 12.
SEE SWEEPSTER
®
MANUAL
FOR SWEEPSTER
®
PARTS.
TRIM INPUT SHAFT
6--1/2
17
16
35
37
30
40
18
8
7
2
1
CD4649A-1
1. Fixed angle sweeper mount
2. Lever
7. Output shaft
16. Spring
17. 20 - Link chain
18. Lever guide
30. Cotter pin
35. Hex head cap screw
37. Elastic stop nut
40. Standard flat washer