Filter
Top Products
38 Assembly
MAN0764 (11/5/2008)
WING ASSEMBLY
Install Wing
Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy com-
ponents.
Figure 29. Right Wing Installation (Typical)
The wing must be installed in the following sequence
and will require at least two people. A floor jack or a
suitable lifting device will be helpful to align decks when
installing the hinge pin.
1. Remove hinge pin (13) from center section.
2. Place wing assembly adjacent to the center section
and align hinge sections.
3. Insert hinge pin through the hinge sections and
secure with spring pin (67) and washer (35) on
both ends.
4. Repeat procedure of opposite wing.
Install Wing Cylinder and Transport Lock
(Figure 30)
1. Slide rod end of wing cylinder (5) through box end
of wing transport lock bracket (20).
2. Place base end of cylinder and wing transport lock
bracket over cylinder lug on center section and
align holes. Secure to cylinder lug using clevis pin
(19) and two cotter pins (63).
3. Remove plug from base end of hydraulic cylinder
and rod end of cylinder.
4. Extend cylinder fully and replace plug in base end
of cylinder. This trapped air will help push wing
down.
5. Align cylinder rod end with slotted holes on wing
cylinder lugs and secure using clevis pin (18) and
two cotter pins (63).
6. Insert lock-up pin (29) in lower hole and secure
using lynch pin (40).
7. Install bushing (24) and elbow (23) to the rod end
of cylinder (5). Position elbow to point to the center
section.
Figure 30. Wing Cylinder and Wing Transport Lock Installation
CAUTION
13. Hinge pin
33. 1" Flat washer
64. Spring pin, 1/4 x 1-1/2
5. Hydraulic cylinder
18. 1" x 4.58" Clevis pin
19. 1" x 5.08" Clevis pin
20. Wing transport lock
23. 1/4 NPT x 1/4 NPT Elbow, restricted
24. 1/2 NPT x 1/4 NPT Reducer bushing
25. 1/4 NPT x 1/4 NPT x 264" Hose
29. 1 x 8.41 Headless pin
33. 1" SAE Flat washer
40. Lynch pin, chain and cotter assembly
63. 1/4 x 1-1/2 Cotter pin