Filter
Top Products
36 Assembly
MAN0764 (11/5/2008)
Figure 26. Tongue Installation
Install Tongue (Figure 26)
NOTE: Route center and wing cylinder hoses before
proceeding. See Install Hydraulic Hoses, page 33, for
hose routing instructions.
NOTE: Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy compo-
nents.
1. Attach tongue (28) to the center section using two
1-1/4 pivot pins (4), carriage screws (75), and hex
nuts (50).
2. Thread hex nut (73) onto tongue level link (26).
Raise tongue and insert level link through center
pivot casting.
3. Attach each attitude rod (6) between the lugs on
tongue and secure with spacer (83), clevis pin (5),
carriage screw (75), and lock nut (50).
4. Attach parking jack (29) to the side of the tongue.
5. Attach second hex nut (73) to tongue level link (26)
on the back side of center pivot casting.
6. Attach hose holder (31) to the top of the tongue
using two cap screws (53) and lock nuts (50).
Install 3-Joint Drive (Figure 27)
Before installing cutter input driveline to gearbox, check
the tag wired to the driveline and the tag wired to the
input shaft of gearbox. Ensure the tag rpm speeds
match the rpm speed decal on front of cutter. After con-
firming all speeds match, remove and discard tags and
then complete driveline assembly.
1. Attach H-frame (30) to tongue with two bolts (77),
sleeves (47), cup washers (60), and nuts (62).
2. Coat splined end of gearbox input shaft with
grease.
3. Slide drive (33) onto shaft and align hole in drive
yoke with groove on gearbox input shaft.
4. Secure with bolt and nut supplied with drive.
5. Secure driveline carrier bearing to H-frame with pin
(69) and cotter pin (70).
4. Pivot pin, 1-1/4
5. Pivot pin, 1
6. Attitude rod
24. Spacer
23. Retainer
25. Clevis
26. Tongue level link
27. Tongue level bracket
28. Tongue
29. Parking jack (not shown)
31. Hose holder
45. 5/8 NC x 4-1/2 Hex head cap screw GR5
50. 1/2 NC Flange lock nut
53. 1/2 NC x 1-1/4 Hex head cap screw GR5
62. 5/8 NC Lock nut
73. 1" NC Hex nut
75. 1/2 NC x 1-1/2 Carriage bolt
83. Spacer, 1" x 1"