Filter
Top Products
Assembly 37
MAN0654 (Rev. 10/19/2007)
Install Slip Clutch Driveline
Figure 32. Slip Clutch Driveline Assembly
A new slip clutch, or one that has been in storage over
the winter, may seize.
NOTICE
■ A grade 8.8 metric bolt must be used to attach
clutch driveline to gearbox.
1. Before operating slip clutch, make sure it will slip.
Refer to SLIP CLUTCH adjustment, page 22.
2. Position the shield (3) against gearbox. Install
shield and torque bolts (5) to 12 lbs-ft.
3. Install driveline onto gearbox input shaft and
secure with bolts (1) and nuts (2).
4. Lubricate rear driveline half and install front
driveline half.
INSTALL SAFETY SHIELDING
Install Optional Chain Shielding
Full chain, rubber, or steel band shielding must
be installed when operating in populated areas or
other areas where thrown objects could injure peo-
ple or damage property.
• If this machine is not equipped with full chain,
rubber, or steel band shielding, operation must
be stopped when anyone comes within 300 feet
(92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition.
It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
The optional chain shielding assemblies are ready for
installation when you receive them.
1. Refer to Front & Rear Chain Shielding, page 58
and attach as shown by inserting the bolts from
inside the cutter frame out through the shielding.
2. Install hardware as shown in the parts drawing.
Install Rubber Deflector
1. Attach rubber deflector (1) and link (2) to front of
cutter using carriage bolts (3) and flange lock nuts
(4).
2. Insert bolts from inside the cutter frame out through
the shielding.
Figure 33. Rubber Deflector and
Foot Guard Installation
FILL GEARBOX
NOTICE
■ Gearbox is not filled at the factory. Prior to
delivery to customer, make sure gearbox is filled
only half-full with 80W or 90W API GL-4 or GL-5
gear lube. Use side hole to remove any excess oil.
1. Remove vent plug/dipperstick (9) on top of gearbox
and plug on side of gearbox. Use 5/16" allen
wrench to remove plug.
2. Make sure vent plug hole is clear.
3. Fill gearbox until oil runs out the side hole on
gearbox. Use a high quality gear oil with a viscosity
index of 80W or 90W and an API service rating of
GL-4 or GL-5.
4. Install side plug and vent plug.
1. 12 mm x 1.5P x 65 mm
Cap screw GR8.8
2. 12 mm x 1.5P Hex lock nut
3. Clutch shield
5. M8 x 1.25P x 20 mm Cap screw
6. 5/16 Lock washer
7. 5/16 Flat washer
8. Anti-rotation chain
9. Vent plug/Dipperstick
1. Rubber deflector
2. Link
3. 3/8 NC 1 Carriage bolt
4. 3/8 NC Flange lock nut
(Rev. 7/9/2010)