Filter
Top Products
32 Assembly
MAN0680 (11/30/2007)
BAFFLE KIT INSTALLATION (OPTIONAL)
NOTE: An optional baffle kit may be installed to the
front of the cutter to prevent excessive blow-out when
cutter is used on a non-cab tractor. The baffle can also
be installed in the rear of the cutter to spread out dis-
charge.
1. From the bottom of the cutter, drill two 21/64" holes
in the rectangular tubes using dimensions A, B and
C from chart in Figure 34. Drill holes in either front
or rear of cutter.
2. Attach L-shaped mounting brackets (2) to the
bottom of the deck using self-tapping screws (5).
3. Place baffle (1) against mounting brackets (2) and
secure using two carriage bolts (3) and flange lock
nuts (4).
4. Baffles located in the front of cutter: Push end of
baffle against cutter side frame drill hole through
side frame using hole in baffle as a guide. Secure
baffle to side frame using carriage bolts (3) and
flange lock nuts (4).
5. Baffle located in the rear of cutter: Secure baffle to
side frame using carriage bolts (3) and flange lock
nuts (4).
NOTE: Mounting brackets must be welded to the
deck, screws alone will not be enough to hold
mounting brackets in place.
6. Weld mounting brackets to bottom of deck. Weld
solid on three sides.
Figure 34. Baffle Installation
1. Baffle kit, BB6000X, BB7200X, BB8400X
2. Mounting bracket
3. 3/8 NC x 1 Carriage bolt GR5
4. 3/8 NC Flange lock nut
Model ABCD
BB6000X 2.72" 6.56" 6.22" 27°
BB7200X 2.45" 5.99" 8.32" 22.5°
BB8400X 2.32" 5.23" 10.55" 19°