Filter
Top Products
10 Assembly
29900 (Rev. 7/6/2007)
Figure 5. Side Skid and Side Shield
SIDE SHIELD OR DISCHARGE CHUTE
INSTALLATION
A side shield and discharge chute are provided for right
side of mower. The side shield should be used for nor-
mal operating conditions. The discharge chute may be
used to replace side shield for very heavy mowing con-
ditions.
■ Do not operate mower unless either discharge
chute or side shield is installed.
■ Keep hands and feet away from mower while
tractor engine is running. Stay clear of all moving
parts.
Left Side Shield Installation
Attach side shield (9) to mower with 3/8 x 1" bolts (21)
and 3/8" flanged lock nuts (24). Insert bolts from inside
out. See Figure 5.
Right Side Shield and Baffle Installation
Attach rear of side shield baffle (5) to mower, and front
portion to right side shield (4) with 3/8 x 3/4" carriage
bolts (20) and lock nuts (25), inserted from inside out.
Figure 6. Side Shield & Baffle Installation
Discharge Chute Installation
Remove side shield (4). Attach discharge chute (13) to
mower frame with 3/8 x 1" bolts (20) and 3/8" flanged
lock nuts (25).
Figure 7. Discharge Chute Installation
OVER-RUNNING CLUTCH INSTALLATION
See page 20. Install the two keys (13) in spindle shaft
and place over-running clutch pulley unit on spindle
shaft with bolted flange on top. Make sure it lines up
with keys in shaft. Place three washers on top of spin-
dle shaft (16), install weather cap (15), and secure with
3/8 x 1-1/2" bolt (14) and lock washer (4).
CLUTCH BELT SHIELD INSTALLATION
See page 16. Install drive belt on pulley, then install
drive shield (6) to mower frame with 3/8 x 1" bolts (21),
3/8" lock washers (23) and nuts (24).
NOTICE
■ This shield is not used when mower is installed
on IH Low Boy tractors because of minimum clear-
ance under tractor.
LA6
ADANGER
ACAUTION
LA8