19
Step 13. Squeeze the belt together and push belt
forward. Press the control arm inward
towards the deck and remove the six
speed cable from the slot.
Step 14. Place the new belt over the transmission
pulley. Start the belt in pulley groove and
rotate pulley until belt is seated in
transmission pulley.
Step 15. Place belt between idler pulley and the belt
keeper bracket.
Step 16. Using pliers, rotate the belt keeper bracket
so that it snaps into slot on the idler
bracket.
Step 17. Tighten the idler pulley bolt and locknut
1/2 turn using two 7/16” wrenches.
Step 18. Pivot the control arm down away from the
pulley and belt.
Step 19.
Step 20. Lift off the lower pulley assembly and
remove the old belt from around the
crankshaft.
Step 21. Place belt between the two pulley halves
on the crankshaft. Make sure to route the
belt inside the belt guard pin.
Step 22. When changing the belt, do not
disassemble the lower pulley assembly.
Belt
Six-Speed
Cable Slot
Control
Arm
Transmission
Belt Keeper
Bracket
Idler Pulley
Belt
Idler Pulley
Bracket
Transmission
Pulley
Bolt and
Locknut
Control
Arm
Six-Speed
Cable Slot
Belt
Lower Pulley
Half
Crankshaft
Belt
Lower
Pulley
Half
Upper
Pulley
Half
Belt
Pin
Tab
Guard