Filter
Top Products
10
Blade Control Handle
The blade control handle is located on the upper handle of the mower. See Figure 5 . The blade control handle must
be depressed in order to start and operate the unit. Release the blade control handle to stop the engine and the
blade.
WARNING: The blade control handle is a safety device. Never attempt to bypass its operations. The
blade will be rotating whenever the engine is running.
Throttle Control
The throttle control is located on the engine. It is used to regulate the engine speed.
WARNING: The throttle control cannot be used to stop the engine. Do not adjust the throttle
control with the engine running.
Ignition Switch (Electric Start Unit Only)
The ignition switch is located on the left side of the handle panel. It is used for starting only. See Figure 6.
Figure 6, Electric Start Unit Only
Recoil Starter
The recoil starter handle is attached to the upper handle. See Figure 5. Stand behind the unit in the operating
position to start the unit.
Drive Clutch Control
Squeeze the drive clutch control to engage the drive system; release to disengage. Release the clutch control to
slow down when negotiating an obstacle, making a turn or stopping.
Shift Lever
The shift lever is located on the drive clutch control housing on the upper handle. See Figure 5. This lever is used to
select the forward speed of the mower. When changing mower speed, release the drive clutch control.
NOTE: Move the shift lever only when the engine is running. Changing the shift lever setting with the engine off can
cause damage to the mower.
Cutting Height Adjustment Lever (Model 950 Thru 959)
The cutting height adjustment lever is located above the left rear wheel. To adjust the cutting height, pull the lever
out and away from the mower. Then move it forward or back to the desired cutting height. See Figure 5.
Ignition switch