Filter
Top Products
12
Auger Control
To adjust the auger control, refer to page 13.
Shift Cable
If the full range of speeds (forward and reverse) cannot
be achieved, refer to the figure to the left and adjust the
shift cable as follows:
1. Place the shift lever in the fastest forward speed
position.
2. Loosen the hex nut on the shift cable index bracket.
See Figure 3.
3. Pivot the bracket downward to take up slack in the
cable.
4. Retighten the hex nut.
5. Check for correct adjustment before operating the
snow thrower.
Chute Assembly
The distance snow is thrown can be adjusted by changing
the angle of the chute assembly. To do so:
1. Stop the engine by removing the ignition key and
loosen the plastic wing knob found on the left side of
the chute assembly.
2. Pivot the chute upward or downward before retighten-
ing the wing knob. See Figure 4.
Skid Shoes
The space between this shave plate and the ground can
be adjusted. For close snow removal, move the skid
shoes upward on the auger housing. Move the skid shoes
downward on the auger housing when area to be cleared
is uneven.
1. Adjust skid shoes by loosening the four lock nuts
and carriage bolts and moving skid shoes to desired
position. See Figure 15.
2. Make certain the entire bottom surface of skid shoes
are against the ground to avoid uneven wear on the
skid shoes.
3. Tighten nuts and bolts securely.
IMPORTANT: It is not recommended that you operate this
snow thrower on gravel, as loose stones can be easily
picked up and thrown, resulting in personal injury
or damage to the snow thrower. If for some reason,
you must operate the snow thrower on gravel, adjust
the skid shoes for maximum clearance between the
ground and the shave plate
5
Making
Adjustments
Figure 3
Figure 4
Figure 5
WARNING
Read, understand,
and follow all instruc-
tions and warnings
on the machine and
in this manual before
operating.
Never attempt to
make any adjust-
ments while the
engine is running,
except where speci-
fied in operator’s
manual.