Filter
Top Products
Lighting Standing Pilots
To light Cooktop Pilots:
I
I
1.
Make sure all controls are OFF.
2. Remove the grates and reflector
pans from cooktop. Lift the cook-
top and rest on support rod.
3. To Ilght, hold a lit match over the
pilot light located between the
front and back burners. The pilot
flame should be Yd to J/a in
(.6X-.953 cm) high.
4. If the pilot flame needs adjust-
ment, turn the pilot adjustment
screw on the manifold pipe.
5. Lower the cooktop and replace
the grates before using the sur-
face burners.
To light Oven Burner Pilot:
1.
Make sure the oven control is OFF.
2. Remove the broiler drawer. Slide
drawer out to stops, lift both sides,
then slide the rest of the way out.
3. Hold a lit match over the oven
burner pilot located at the rear of
the burner.
4. After the oven burner pilot is burn-
ing steady. check burner lighting
by turning the Oven Control to a
temperature abovel4O”F (60°C).
The burner will take 50-60 seconds
to light.
5. Replace the broiler drawer.
11