Filter
Top Products
Owner’s Record
Date Purchased __________________________________________________________
Purchased From __________________________________________________________
Installed By _______________________________ Date _________________________
Spa Serial Number __________________________ Model No. C460000 _____________
(See page 2 for location of number)
IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL INSTRUCTIONS
o
Jacuzzi Whirlpool Bath does not recommend spa water
temperatures in excess of 104° F. High water tempera-
tures in excess of 104° F. and prolonged periods of use
can raise internal human body temperature excessively
and impair the body’s ability to regulate its internal
temperature. Limit your initial use of the spa to 10 - 15
minutes. High body temperatures affect people differ-
ently; consult your physician about your safety and
comfort before using the spa.
The elderly, the infirm, and children should not use the
spa unattended. Infants should not be permitted in the
spa at water temperatures over 100° F.
Extra care should be taken when using the spa and
consuming alcoholic beverages. Alcohol, drugs, or
certain medications such as tranquilizers affect a person’s
ability to withstand high temperatures and may produce
dangerous effects.
The wet surface of the spa is slippery. Use care when
entering and exiting.
When using the electrical equipment, basic safety
precautions should always be followed:
Connect the spa only to a properly grounded receptacle.
(See details in Installation Instructions.)
This unit is provided with a ground fault circuit interrupter
(GFCI) located in the System Control Module. Check to
be sure this is operational at least once a month. (The
procedure for testing is described on page 9 of this
manual.)
Do not use electrically connected devices such as
television, radio, or stereo speakers, lights, cooking
devices, or telephones within 5 feet of the spa while the
spa is being used. Lighting fixtures must not be located
directly above or within 5 feet of the spa. If located within
10 feet of the spa, they must be on a circuit protected by
a GFCI.
The spa must be installed with adequate access and
water drainage system. (See Installation Instructions.)
Do not turn on power to the spa unless it is filled with
water to the normal water level, which is 6" below the top
of the spa rim. Activating the spa when there is an
insufficient amount of water can damage the circulation
pump and heater and may cause a fire.
Keep body, hair, and clothing a minimum of 12 inches
away from suction fitting and skimmers at all times when
the spa is operating. Hair longer than shoulder length
should be secured close to the head, or a bathing cap
should be worn. Do not remove the suction grille! It is
a safety device and must always be in place on the
suction fitting to minimize the potential hazard of hair
entanglement or body entrapment.
Read manufacturer’s safety information provided with
all optional equipment.
For good hygiene and to advoid health hazards from
contaminated water, maintain properwater chemistry
per instructions under Maintenance in this manual.
Save These Instructions for Future Use.