Whirlpool PORTABLESPA Hot Tub User Manual


 
OPERATION
Basic Control Set-Up (Continued)
Open the skirt door giving access to the electrical
cabinet.
Your spa is provided with a ground fault circuit inter-
rupter (GFCI). At initial start-up and at least once a
month thereafter, with the plug connected to power,
push the test button located on the spa electrical
panel. The reset button should pop out. Push this
button in to reset. If the interrupter fails to operate in
this manner, there is a ground current flowing or a
device malfunctioning, indicating the possibility of
electric shock. Disconnect the plug from the recep-
tacle and do not use the spa until the source of the
breakdown has been identified and corrected.
Make sure the circuit protector buttons are pushed in.
Locate the HIGH TEMPERATURE SAFETY SWITCH,
which is a raised button on the end of the heater. Push
this button to be sure it is in the reset mode. The
purpose of this switch is to shut down the spa if the
water becomes excessively hot. If, for some reason,
the switch is tripped, the reset button must be pushed
in for the heater to operate again after the water has
cooled to about 90°F.
Set the built-in timer (see below).
Close the redwood skirt door.
9
Setting the Timer
The built-in 7-day timer is located in the electrical cabi-
net. The tooth-like tabs that are located on the dial can
be set to activate the filter system for two-hour periods
on any day(s) of the week. First set the correct time. Set
the time of day by rotating the outer dial and aligning the
correct time with the small arrow in the inside of the dial.
Note: both correct time and day must be set. Next slide
one of the tabs toward the center of the dial at the time
at which you wish the filter system to operate. Note that
the timed mode can begin at any time of day or night on
any specified day of the week.
PUSH IN ONE TAB
FOR EACH TWO
HOUR PERIOD OF
OPERATION
M
o
n
d
a
y
T
u
e
s
d
a
y
W
e
d
n
e
s
d
a
y
T
h
u
r
s
d
a
y
F
r
i
d
a
y
S
a
t
u
r
d
a
y
S
u
n
d
a
y
TIMER
HIGH TEMPERATURE
SAFETY RESET BUTTON