Filter
Top Products
TROUBLESHOOTING GUIDE
PROBLEM
7. No water flow from jets.
A. Unit not plugged in.
B. Selector switch in OFF.
C. House circuit breaker tripped;
no power to system.
D. Spa circuit breaker tripped.
E. High temperature safety switch
tripped.
F. GFCI tripped.
G. Faulty pump or motor.
A. Plug unit in.
B. Select other function.
C. Reset circuit breaker.
D. Reset circuit breaker
E. Reset button on heater after
water has cooled; *Note
if switch continues to trip.
F. Reset GFCI
G. *
10. Motor will not start.
8. Noisy pump and motor.
A. Clogged strainer(s).
B. Leakage of air into suction line.
C. Vibrating parts attached to moto
or support brackets
D. Low water level.
E. Damaged or worn motor
bearings.
F. Impeller rubbing inside case.
G. Debris inside pump.
A. Clean strainer(s).
B. Locate and repair leaks.
C. Tighten fasteners.
D. Add water to normal water
level.
E. *
F. *
G. *
9. Water leakage at pump shaft
(rotating connection between
pump and motor).
A. Worn or damaged pump seal. A. *
A. Plug in unit
B. Select FILTER, HTR/FILTER,
or
JETS mode.
C. Select OFF, ACC mode.
D. Reset circuit breakers.
E. Reset GFCI.
G. *
H. Reset buttons on heater after
water has cooled; see *Note
A. Unit not plugged in.
B. OFF mode selected.
C. Blower selected (115 VAC).
D. House circuit breaker
tripped or in OFF position.
E. Spa circuit breakers tripped.
F. GFCI tripped.
G. Improper or defective wiring.
H. High temperature safety
switches tripped.
I. Inadequate eletrical supply
J. Locked shaft or impeller.
K. Motor windings burned out.
L. Defective starting switch
inside motor.
I. *
J. *
K. *
L. *
if switch continues to trip.
*Note: The skills and tools necessary for the safe repair of this spa require the services
of qualified service personnel. Contact your dealer.
PROBABLE CAUSE
REMEDY
19