Filter
Top Products
4
discontinue the u seof this tool and seekmed-
ical attention. An anti-vibration system does
not guarantee the a voidance of these prob-
lems. Users who operate power tools on a
continual and regular basis must monitor
closely their physical condition and thecondi-
tion of this tool.
SAVE THESE INSTRUCTIONS
ASSEMBLY
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged part s.
NOTE:
If you need assistance or find parts
missing or damaged, call 1-800-554--6723.
This instruction manual has been developed
to help you assemble the unit and to prov ide
its safe operation. Itisimportant that youread
the entire manual to become familiar with the
unit
before
you begin assembly.
Read your instruction manual.
Tools you will need:
S
Adjustable wrench
S
Hex wrench ( provided)
TUBE ASSEMBLY
NOTE:
When performing the following step,
besurethe handle isaligned as follows: label
on top, throttle trigger to the operator’s ri ght
hand side.
The starter rope and the throttle
cable must not wrap around the tube.
Throttle trigger
Label
1. Assemble handle tube to the lower tube (it
will be necessary to pull some of the start-
er rope out of the housing).
2. Align the screw holes; insert the screws
through the aligned holes.
3. Thread one locknut onto each screw and
tighten securely.
Handle tube
Screws
Starter Rope
Locknuts
Lower
Tube
NOTE:
When performing the following step,
be sure the starter rope is not caught under
the cable clamp. The starter rope must hang
freely to operate properly.
4. Align the cable clamp between the tube
screws. Install the cable clamp aroundthe
tube and throttle cable.
Throttle cable
Cable Clamp