Filter
Top Products
7
Theextensioncordusedtoreachthe
power source must be:
D Specifically marked as suitable for out-
door use. The cord must be marked with
the suffix “W”.
D Heavy enough to carry full current f rom
the power source to the unit. Otherwise,
loss of power and ove rheating can occur
causing d amage to unit. Refer t o table f or
minimum wire gauge recommendations.
The cord m ust b e marked wit h the proper
wire gauge. (App ropriate extension c ords
are available.) Do not use multiple cords.
D In good condition. Cord insulation must
be intact with no cracks or deterioration.
Plug connectors must be undamaged.
DO NOT use mult iple cords.
MINIMUM W IRE GAUGE
RECOMMENDATIONS
VOLTS
25 FT. 50 FT. 100 FT.
120 16
A.W.G.*
16
A.W.G.*
*American WireGauge
14
A.W.G.*
Secur e the extensi on cord to the unit by
threading the cord through the cord re-
tainer (see illustration). Insert the cord
rece ptacle into the rece ssed p lug.
CAUTION: Failuretousecordretain-
er could result in damage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit
USING YOUR UNIT
KNOW YOUR ELECTRIC BLOWER/VACUUM
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Compare the illustrations to your unit t o f amiliarize yourself with the location of
the various c ontrols and adjustments. Save this manual for future refe rence.
Top Handle
Air Vents
ON
/
OFF Switch
Inlet Cover
Latch
Rear
Handle
Upper Vacuum Tube
Lower Vacuum Tube
Collection Bag
Blower Tube
Cord
Retainer
Inlet Restrictor
Vacuum Assist Handle
Tube Release Button
Elbow
Tube
Upper Vacuum Tube
Retaining Post
ON/OFF SWITCH
The
ON/OFF SWITCH is used to activate
the motor.
INLET COVER LATCH
TheINLETCOVERLATCH is used toopen
and close the inlet c over and to secure
the upper v acu um tube to the blower
unit.