Filter
Top Products
9
Battery Pack 545124416
Charger 545124415
REPLACEMENT PART PART NUMBER
USER REPLACEABLE SERVICE PARTS
STORAGE
WARNING: Perform the following
steps after each use.
S St op the unit and remove the battery pack
when not in use.
S C arry the unit with motor stopped.
S St ore the unit so the blades cannot cause
injury.
S St oreunit indoor sin ahigh, dr yplace outof
the reach of children.
S St ore unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
BATTERY DISPOSAL
WARNING: Remove the battery pack
from the hedge trimmer . Cover the terminals
with heavy duty adhesive tape. Do not attempt
to destroy or disassemble battery pack o r re-
move any of its components. Nickel--cadmium
batteries must be recycled or disposed of prop-
erly.Also, never touch bothterminals with metal
objects and/or body parts to avoid short circuit-
ing the battery pack. Keep awa y from chil dren.
Failure to comply with these warnings could re-
sult in fire or serious personal i njury.
S To preserve natural resources, please re-
cycle or dispose of batteries properly.
S T hisproductcontains nickel--cadmiumbatter-
ies. Local, state or federal laws may prohibit
disposal of nickel--cadmium batteries in ordi-
nary trash.
S C onsult yourlocalwaste aut hority forinfor-
mationregardingavailablerecyclingand/or
disposal options.
TROUBLE CAUSE REMEDY
Unit fails to
operate
1. Remove battery and check connectors.
Replace battery.
2. Charge battery pack.
3. Remove debris.
Cutting blades
stop under a
load or do not
move when
trigger switch
is pressed
1. Cut at a slower pace.
2. Clean debris from blades.
3. Charge battery pack.
4. Co ntac t your authorized service dealer.
Poor cutting
quality
1. Ensure the product is being used
correct ly .
2. Clean debris from blades.
3. Contact your authorized service dealer.
Excessive
vibration
1. Contact your authorized service dealer.
TROUBLESHOOTING TABLE
1. Damaged blades.
1. Unit is being used
incorrectly.
2. Blades clogged with
debris.
3. Damaged blades.
1. Forcing blade into
material being cut.
2. Blades clogged with
debris.
3. Battery needs charging.
4. None of the above
1. Battery not attached to
unit correctly.
2. Battery needs charging.
3. Debris stopping blade.
WARNING: Always stop unit and remove battery pack before performing all of the
recommended remedies below except remedies that require unit to be operating.