Filter
Top Products
8
REFILLING THE SPOOL WITH LINE
WARNING: Use only 0.065 inch
(1.65 mm)diameter roundline. Othersizes
and shapes of line will not advance properly
and will result in improper cutting head func-
tion or can cause serious injury. Do not use
othermaterials suchaswire,string,rope,etc.
Wirecanbreakoffduringcutting andbecom e
a dangerous missile that can cause serious
injury.
1. Cut a lengthof 25feet of0.065 inch (1.65
mm) diameter round WEED EATER
brand line.
Feed line in
direction
shown on
spool.
Spool
2. Insert one endof line intocenter cavity of
empty spool. Ensure line will feed into
spool in the direction shown on the spool
(counterclockwise).
3. Continue feeding line into spool, leaving
4 -- 6 inches (10 -- 15 cm) unwound from
center of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring
Replacement Spool
Slot
3. Rest guide ringon spool and place linein
slot. Allowlinetoextend4-- 6inches(10--
15 cm) from center of spool.
4. Ensurelineremains inslotwhilescrewing
cap on to the shaft. Only tighten cap
hand tight!
USER REPLACEABLE SERVICE PARTS
Spool with 0.065 inch Trimmer Line 952711602
Line Guide Ring 530403949
Cap Assembly 530403810
Assist Handle 530403805
Bolt Carriage, 1/4 -20 530403886
Wing Nut 530016152
Shield Assembly 530403914
Edge Guide 530403824
REPLACEMENT PART PART NUMBER
STORAGE
WARNING: Perform the following
steps after each use.
S Stop the unit and disconnect the power
source when not in use.
S Carry the unit with motor stopped.
S Store the unit so the line limiter blade can-
not cause injury.
S Store unit and extension cord indoors in a
high, dry place out ofthe reach of children.
Store unit un plugged.
S Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.