Filter
Top Products
9
TROUBLE CAUSE REMEDY
Trimmer head
stops under a
load or does not
turn when switch
is pressed.
1. Allow tip of line to do the cutting.
2. Contact you r authorized se rvi ce dealer.
3. Check Breaker Box.
4. Remove debris.
Line does not
advance or
breaks while
cutting.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 in. (1.65 mm) dia. line.
4. Remove cover and pull 4 inches
(10 cm) of line out of head.
5. Clean unit.
Line welds onto
spool.
1. Use only 0.065 in. (1.65 mm) dia. line.
2. Replace with correct spool.
3. Cut wit h tip of line fully extended.
Line releases
continuously.
1. Check line routing.
2. Replace spool.
Line pulls back
into head.
1. Too little line outside
of head.
2. Line size incorrect .
1. Remove cover and pull 4 inches
(10 cm) of line outside of head.
2. Use only 0.065 in. (1.65 mm) dia. line.
TROUBLESHOOTING TAB LE
1. Line im properly
routed in head.
2. Spool damaged.
1. Line size is incorrect.
2. Inco rrect spool.
3. Line is being crowded
against material being
cut.
1. Line im properly routed
in head.
2. Line im properly
wound into spool.
3. Inco rrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Cr owding trimmer line
against material being
cut.
2. Electrical failure.
3. Thrown circuit breaker.
4. Debr is stopping head.
Line usage is
exce ssive.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully e xtended.
4. Replace spool.
1. Line improperly routed
in head.
2. Line size is incorrect.
3. Cr owding line against
material being cut.
4. Spool worn or damaged.
WARNING: Alwa ys stop u nit anddisconnect fromth e p ower sourcebeforeperforming
all of the reco mmended remedies below exce pt remedies that require unit to be operat ing.