Filter
Top Products
6
4. To attach the lower vacuum tube to
theuppervacuumtube,firstalignthe
arrowsonthetwotubes.Then,press
thetwotubestogetheruntilthelower
tube is securely seated in the upper
tube (about 3 inches).
Align arrows on upper
and lower tubes
Lower TubeUpper Tube
COLLECTION BAG ASSEMBLY
1. Open the zipper on the collection
bag and insert the elbow tube.
2. Push thesmallend oftheelbowtube
throughthesmallopeninginthebag.
NOTE: Make s ure edge of the small
opening is flush against the flared area
of the elbow tube and the hole for the
tube release button is on top.
Small
Opening
Zipper
Opening
Elbow Tube
Tube
Release
Button
Hole
3. Close the zipper on the bag. Make
sure the zipperis closed completely.
4. Align the grooves on the elbow tube
with thegrooves onthebloweroutlet.
5. Push the elbow tube onto the blower
outlet until it snaps into place (elbow
tube is secured by red tube release
button).
ADJUSTINGTHESHOULDERSTRAP
ON THE COLLECTION BAG
1. Carefully loop the shoulder strap
throughthebuckleasshownintheil-
lustration below.
First In
Last I n
2. Position the unit on your right-hand
side, blower outlet and bag pointing
toward the rear. Hold the unit in an
upright position with the lower vacu-
um tube on the ground to support it.
3. Place the shoulder strap over your
head and onto your left shoulder.
4. Adjustthes traptoallowafreeflowof
air from the blower. If the collection
bagiskinked,theunitwillnotoperate
properly.
NOTE: The strap is designe d to po si-
tion the c oll ection bag on your shoulder
wit hout ki nks. The st r ap i s not intended
to support the weight of the unit .
Shoulder strap
on left shoulder
No kinks in bag
allows free air flow
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. S top unit and unp lug the ext e ns i o n
cord.
2. R em ove t he vacuum t ub es by i nse rt-
ing the ti p of a scr ewdr i ver into t he
latch a rea on th e vacu um assist han-
dle. Gentl y tilt handle of screwdri ver
towar d the front of the unit to release
the latch while pulling up on the vacu-
umassisthandlewithyour ot herhand.
Latch Area
Vacuum
Assist
Handle
3. Install the inlet restrictorthat was re-
movedwhenassemblingforvacu um
use.
NOTE: If you are unable to locate the
inlet restrictor, the unit will still operate.
This restrictor improves the blower
function.
4. Remove the collection bag.
5. Close the inlet cover and make s ure
it is latched closed.
6. Re-i nst allthe bl ower tube.Refer to
AT-
TACHING THE BLOWER TUBE
for
instruct ions on how t o at tach t his item.
SELECT AN EXTENSION CORD
Use only a 120 A.C. v oltage supply as
shown on nameplate of the unit to
power your blower.