Filter
Top Products
Immediately prepare your unit for storage at the end of the
season.
STORAGE INSTRUCTIONS
If our blower isto be stored for a pedod of time, clean it
thoroughly before storage. Remove any dirt, leaves, debris,
etc, Store in a clean dry area.
• Disconnectfrom the power source.
• Clean the entire unit.
• Open Inlet coverand clean any dirt, grass, ordebris that
has collected. Inspect the blower and vacuum tubes.
Close and replace screw.
• Clean air vents and air inlet of debris.
• Reassemble all loose parts, being sure that all handles
are in place and are securely fastened. Replace any
damaged parts.
• Store your unit in a well ventilated area and covered, if
possible, to prevent dust and dirt accumulation. Do not
coverwith plastic. Plastic cannot breathe and will induce
condensation and eventual rust or corrosion.
..... m.lllllll i liH i ,,,,,,,,,,,,,,,,,,,,,,,,Hill. ,,,,, .ll illl i i.H. i ,,.,,, ,,,,,,,,,,,,,,,,,,,,,,, , ,, .............................
TROUBLESHOOTING POINTS
........... I ii iiiiiiiiiiii i I i iiiiiiiiiii ii IL== ,H ,=, ,,,...............................................................................
TROUBLESHOOTING CHART
REMEDYSYMPTOM
Unit fails to operate.
Unit vibrates abnormally.
Impeller will not tum freely.
CAUSE
,,,i ,,,,,,,, ...... ,,i ............ J
A. Switch in the OFF position.
B. Disconnected from power source.
C. Circuit breaker tripped, or fuse
blown.
D. Mechanical failure.
, ,,,,,,,,,,
A. Mechanical failure.
A. Debris in air intake area.
B. Mechanical failure.
A. Push switch to the ON position.
B. Reconnect unit to power source.
C. Reset circuit breaker, or replace fuse.
D. Contact your Sears Service/Dept.
A. Contact your Sears Service/Dept.
.................... u
A. Clean unit. Remove any debds.
B. Contact your Sears Service/Dept.
ff situations occur which are not covered in this manual, use care and good judgement.
ff you need assistance, contact your Sears Service Center!Department or the
CUSTOMER ASSISTANCE HOTLINE at 1-800-235-5878
- ]3 -