Troy-Bilt TB75SS Trimmer User Manual


 
9
LINE INSTALLATION FOR THE SPEEDSPOOL
®
Always use original equipment manufacturer 0.095 inch (2.41 mm)
replacement line. Lines other than the specified may make the
engine overheat or fail.
There are two methods to replace the SpeedSpool
®
trimming line:
• Wind the inner reel with new line
• Install a pre-wound inner reel
Winding the Inner Reel With New Line
NOTE: It Is unnecessary to remove the bump knob to install a
new trimming line.
1. Cut two pieces of 0.095 inch (2.41 mm) trimming line, 10
feet (3 m) long.
2. Hold the outer spool and turn the inner reel counterclockwise
to line up the arrows on the outer spool and inner reel (Fig. 15).
Top View Of The SpeedSpool
®
Outer Spool
Inner Reel
Fig. 15
Bump Knob
Arrows
MAINTENANCE SCHEDULE
Perform these required maintenance procedures at the
frequency stated in the table. These procedures should also be
a part of any seasonal tune-up.
NOTE: Some maintenance procedures may require special
tools or skills. If you are unsure about these procedures
take your unit to any non-road engine repair
establishment, individual or authorized service dealer.
NOTE: Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
non-road engine repair establishment, individual or
authorized service dealer.
In order to assure peak performance of your engine, inspection
of the engine exhaust port may be necessary after 50 hours of
operation. If you notice lost RPM, poor performance or general
lack of acceleration, this service may be required. If you feel
your engine is in need of this inspection, refer service to any
non-road engine repair establishment, individual or authorized
service dealer for repair. DO NOT attempt to perform this
process yourself as engine damage may result from
contaminants involved in the cleaning process for the port.
MAINTENANCE AND REPAIR INSTRUCTIONS
WARNING: Never use metal-reinforced line,
wire, chain or rope. These can break off and
become dangerous projectiles.
WARNING: To prevent serious injury, never
perform maintenance or repairs with unit running.
Always service and repair a cool unit. Disconnect the
spark plug wire to ensure that the unit cannot start.
WARNING: Always use the correct line length
when installing trimming line on the unit. The line
may not release properly if the line is too long.
FREQUENCY MAINTENANCE REQUIRED REFER
Before starting Fill fuel tank with fresh fuel Page 3
Every 10 hours Clean and re-oil air filter Page 12
Every 25 hours
Check and clean spark arrestor
Check spark plug condition
and gap
Page 12
Page 14
Every 50 hours
Inspect exhaust port and spark
arrestor screen for clogging or
obstruction to assure
maximum performance levels
Page 12
Line Locking Hole
Trimming Line
Line Loading Hole
Eyelet
5. Insert the line into the locking hole (Fig. 17). Do not push
the line more than a 1/2 inch (12.7 mm) into the line locking
hole. The line will form a small loop (Fig. 17) when it is
inserted correctly.
3. Pull old line out of the line loading and line locking holes
(Fig. 16 and 17).
4. Insert a piece of trimming line straight into one of the two
eyelets in the outer spool. Push it up through the line
loading hole in the inner reel (Fig. 16). Do not bend the line
when inserting it into the eyelet.
Fig. 16
Fig. 17