Filter
Top Products
Edging Along A Curb
The right, rear wheel of the edger can be lowered into one of five
positions to ease the task of edging along a curb. To adjust the
height of curb wheel, proceed as follows:
Lower the right, rear wheel by moving the curb height
adjustment lever slightly to the left. See Fig. 5–2.
Pivot the right, rear wheel into an applicable position in
relation to the height of the curb to be edged along. See
Fig. 5–2
Release the curb height adjustment lever to lock the wheel
in position. See Fig. 5–2.
1.
2.
3.
Beveling
In order to achieve a bevelled edge, set the bevel adjustment
lever (refer to Assembly & Set-Up Section) in the first (left hand)
or third (right hand) notch to place the edger blade in position
for beveling (See Fig. 5–3).
1
2
3
Curb Height
Adjustment
Lever
Figure 5-2
Right-Hand Position Left-Hand Position
Figure 5-3
10 sectiOn 5— OperatiOn