Filter
Top Products
MAINTENANCE AND REPAIR INSTRUCTIONS
9
Fig. 10
Fig. 9
Fig. 8
Fig. 11
EDGER BLADE REPLACEMENT
1. Line up the hole in output shaft with the locking rod
slot. Insert the locking rod through the slot into the
output shaft hole (Fig. 7).
2. Hold the locking rod in place by grasping it next to
the boom of the unit (Fig.8).
3. While holding the locking rod, loosen the nut on the
blade by turning it clockwise with a 13 mm wrench
(Fig. 9). Remove the nut, retaining washer and blade.
Keep the nut and blade retainer for installation.
4. Install the new blade, blade retainer, and nut
(Fig. 10). Insert the locking rod through the slot into
the output shaft hole. Make sure that the blade stays
flat and centered against the output shaft while
tightening the lock nut counterclockwise (Fig. 11).
5. If you have a torque wrench, tighten the nut to
325-335 in.•lbs (37-38 N•m), while holding the
locking rod in the slot.
If you do not have a torque wrench, hold the locking
rod in the slot. Rotate the nut counterclockwise with
a 13 mm closed-ended or socket wrench, until the
nut presses against the washer and the blade is
snug. Make sure the blade assembly is installed
correctly, then rotate the nut an additional 1/4-1/2
turn (Fig. 11).
6. Remove the locking rod.
Fig. 7
Locking Rod
Locking Rod
Locking Rod
Blade Retainer
Lock Nut
Loosen
Tighten
Edger Blade
Output Shaft
Hole
Locking Rod Slot
Output Shaft
WARNING: To avoid serious personal injury,
always wear gloves while handling, removing
or installing the blade.
WARNING: Verify the blade is flat against the
output shaft after the nut is tightened. If the
blade is off-center, the unit will be damaged
by vibration, and the blade may fly off, which
can cause serious personal injury.
WARNING:
The gear housing gets hot after long
periods of use. To avoid serious personal injury,
do not touch the housing until it has cooled.