Filter
Top Products
5
Your Responsibility
Restrict the use of this power machine to persons who read, understand and follow the warnings and instructions in
this manual and on the machine. Not all safety labels shown may apply to your chipper shredder.
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER
IMPORTANT:
This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the
chipper shredder is observed from the operating
position.
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e.,
operator’s manual, etc.)
• Cut along corners, lay carton down flat, and remove
packing material. Roll or slide unit out of carton and
check carton thoroughly for loose parts.
Tools Required
• Two 7/16” Wrenches (or adjustable wrenches)
Loose Parts In Carton (See Figure 1)
• Hopper Assembly
• Discharge Chute
• Chipper Chute
• Bag (Not Shown)
• Tamper Plug (If Equipped)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder, disconnect the
spark plug wire from the spark plug and ground against
the engine.
Figure 1
Discharge
Chute
Hopper
Assembly
Chipper
Chute
Tamper
Plug