Troy-Bilt 2840 Snow Blower User Manual


 
Snow thrower controls and features are described below and

NOTE: For detailed information on all engine controls, refer to

Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward


Reverse

slower and two (2) is the faster.
Choke Control
The choke control is found on the top of the engine and is
activated by rotating the knob. Activating the choke control
closes the choke plate on the carburetor and aids in starting the
engine.
Ignition Key
The ignition key is a safety device. It must be fully inserted in
order for the engine to start. Remove the ignition key when the
snow thrower is not in use.
Note: Do not turn the ignition key in an attempt to start the
engine. Doing so may cause it to break.

Recoil Starter
Handle
Electric Start
Button
Electric Starter Outlet
Primer
Ignition
Key
Stop Switch
Choke
Control
Oil Fill
Drive Control
Chute Assembly
Gas Cap
Shift Lever
Auger Control
Heated Grips
Chute Directional Control
Clean Out
Tool
Augers
Skid Shoe
Controls and Features
4
11