Troy-Bilt 2840 Snow Blower User Manual


  Open as PDF
of 52
 
Auger Control

carefully read and follow all instructions below.

is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged 


In a well-ventilated area, start the snow thrower engine. 2.

While standing in the operator’s position (behind the snow 3.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten 

several times.
5.
walk to the front of the machine.
Confirm that the auger has completely stopped rotating and 

of rotating, immediately return to the operator’s position
and shut off the engine. Wait for ALL moving parts to stop
before re-adjusting the auger control.
To readjust the control cable, loosen the upper hex nut on the 7.

8.
downward to increase cable tension).
Retighten the upper hex nut.

achieved.

10 se c t i O n 3— as s e M b l y & se t-up
 previous next