Filter
Top Products
Maintenance (continued)
25
Lubrication Chart
Engine
Crankcase
First 5
hours
Hydrostatic
Transmission
Front
Wheel Spindles
Front Axle
Pivot
See engine manual
Lubrication intervals vary
with operating conditions
and type of oil used
1-Speed Units: Use SAE
20 wt. Part No. 737-0335
2-Speed Units: Use
Part No. 737-0333
(Benzoil Gear Hydro Oil)
Alternate Oils - Mobil 423,
Amoco 1000 or Texaco TDH
Multi-purpose grease
Multi-purpose grease
Multi-purpose oil
Item
Frequency Type of Lubrication
Amt. Required
25 hours
Check each
use. Change
when oil is
discolored,
dirty or after
100 hours
25 hours or
end of season
25 hours or
end of season
25 hours or
end of season
See engine manual
Fill to within safety
operating zone
As required
As required
As required
1
2
3
4
1
2
FRONT
View from
under tractor.
3
4
Lift Shaft
5
5
Lubricate from
both sides.
NOTE: A hand type grease gun is
recommended when greasing your unit.
High pressure type grease guns could
cause damage to the fittings and bearing
seals. Lubricate all linkages, levers and
pins not equipped with grease fittings,
with an oil can once each week; more
often depending on operating conditions.