Filter
Top Products
12
A pipe-mount adapter is provided to enable sensor installation on a secured section of 1/2" (13mm)
diameter Schedule 40 PVC pipe.
Note: Metal pipe or conduit may interfere with radio signal transmission and is not recommended.
Remove and replace the Quick Clip bracket with the pipe-mount adapter. Ensure the friction
washer is installed between the adapter and housing tabs as shown in Figure 14.
Check the sensor for vertical alignment. To
adjust, loosen the Phillips screw slightly, align
as needed and tighten screw. See Figure 15.
Figure 14
Figure 15
Washer
RainSensorAlpha7 3/10/2005 3:31 PM Page 12