Filter
Top Products
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description
Qty.
Use
Oval-head bolts
2
Curved washers
2
1
Handle knobs 2
Install the handle.
2
No parts required
–
Install the recoil starter handle.
Discharge chute assembly 1
Screws
2
Washers 2
Locknuts 2
3
Knob 1
Install the discharge chute assembly.
4
Bottle of engine oil
1 Fill the engine with oil.
5
No parts required
–
Adjust the control cable.
1
Installing the Handle
Parts needed for this procedure:
2
Oval-head bolts
2
Curved washers
2 Handle knobs
Procedure
1. Position the ends of the upper handle on the inside
of the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes, with
the bolt heads on the outside of the handle (
Figure 3).
Figure 3
1. Oval-head bolt (2) 2. Curved washers and
handle knobs
3. Install the curved washers and the handle knobs
on the oval-head bolts on the inside of the handle
(
Figure 3) and tighten the knobs securely.
Important: Ensure that the cable is routed to
the outside of the handle.
5