Filter
Top Products
4
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
On Handle
73-0460
1. Read the Operator’s
Manual.
2. Electrocution
3. Cutting/dismemberment of
foot, auger
4. Cutting/dismemberment of
fingers/hand, impeller
104-9382
Assembly
Note: Determine the left and right hand sides of the
snowthrower by standing in the normal operating position.
Installing the Upper Handle
and Chute Crank
1. Stand the snowthrower on its wheels and position the
upper handle. Inspect the open internal wiring. If it is
damaged, do not assemble. Contact your Authorized
Service Dealer.
Internal wiring could be damaged during
assembly. Damaged wiring can cause serious
personal injury when operating the snowthrower.
• Carefully assemble the snowthrower so that you
will not damage the electrical wiring.
• If wiring is damaged, do not assemble the
snowthrower. Contact your Authorized Service
Dealer.
Caution
2. Carefully insert the right side of the upper tubing over
the end of the lower right side tubing (Fig. 2).