Filter
Top Products
NOTE: Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum deposits during
storage. Do not drain carburetor if using fuel stabilizer.
• Wipe equipment with an oiled rag to prevent rust.
• Remove spark plug and pour one ounce of engine
oil through spark plug hole into cylinder. Cover
spark plug hole with rag. Crank engine several
times to distribute oil. Replace spark plug.
• Follow the lubrication recommendations found in
the Maintenance Section.
• Always store the snow thrower in a clean, dry area.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings, and cables.
SECTION8: TROUBLESHOOTING
Problem Cause
Engine fails to start 1. Fuel tank empty, or stale fuel. 1.
Engine runs erratic
Loss of power
Excessive vibration
Unit fails
to propel itself
Unit fails
to discharge snow
2. Blocked fuel line.
3. Choke not in the ON position
4. Faulty spark plug.
5. Safety key not in ignition switch on engine.
6. Spark plug wire disconnected.
7. Primer button not being used properly.
8. Fuel shut-off valve closed. (If Equipped)
1. Unit running on CHOKE.
2. Blocked fuel line or stale fuel.
3. Water or dirt in the fuel system.
1. Spark plug wire loose.
2. Gas cap vent hole plugged.
1. Loose parts or damaged auger.
1. Drive control cable in need of adjustment.
2. Drive belt loose or damaged.
1. Chute assembly clogged.
2. Shear pin sheared.
3. Foreign object lodged in auger.
4. Auger control cable in need of adjustment.
5. Auger belt loose or damaged.
6. Shear pin(s) sheared.
Remedy
Fill tank with clean, fresh gasoline. Fuel
becomes stale after thirty days.
2. Clean the fuel line.
3. Move switch to the ON position
4. Clean, adjust gap or replace.
5. Insert the key fully into the switch.
6. Connect spark plug wire.
7. Refer to the engine manual.
8. Open fuel shut-off valve. (If Equipped)
1. Move the choke lever to OFF position.
2. Clean the fuel line; fill the tank with clean,
fresh gasoline.
3. Drain the fuel tank and carburetor. Refill with
fresh fuel.
1. Connect and tighten spark plug wire.
2. Remove ice and snow from gas cap. Be
certain vent hole is clear.
1. Stop the engine immediately and disconnect
the spark plug wire. Tighten all bolts and nuts.
If vibration continues, have the unit serviced
by an authorized service dealer.
1. Adjust drive control cable. Refer to Making
Adjustment Section.
2. Replace drive belt. Refer to the Service
Section.
1. Stop engine and disconnect spark plug wire.
Clean chute and inside of auger housing with
clean-out tool or a stick.
2. Replace shear pin.
3. Stop engine immediately and disconnect
spark plug wire. Remove object from auger
with clean-out tool or a stick.
4. Adjust auger control cable. Refer to the
Making Adjustments Section.
5. Refer to Service Section.
6. Replace shear pin(s).
17